Cat in the Hat Finger
Puppet
Cat in the
Hat Finger Puppet Craft
For the Cat in the Hat, youll need
2 red pipe cleaners, one white,
and two black
(the black used together to make the
finger puppet base)
Plus a 4 inch black
piece bent as shown to make the arms.
First, wind the puppet
base with the two black pipe cleaners.
Then make the "Cat in the Hat"
hat
First
youll wind a red and white pipe cleaner around
your finger to
make the top, then after three turns, start winding
them together to
make the brim. The wire is so easy to work with and
so forgiving, dont
worry if it seems to come out all wonky its
super easy to fix into
whatever shape you want. To make the top of the
hat, simply coil the top
pipe cleaner piece a little smaller as shown in
the last photo in the
series above
Glue the
hat to the white pom pom
Bend two small black
pieces of pipe cleaner as shown for ears, and glue
them to the sides of the head just below the
hat
Cut the
thread into two 1½ inch pieces, and glue them
to the back
of the tiny black nose pom pom. This is a little
tricky because both are
so small younger children might need help with
this part
Glue the
nose to the middle of the front of the cat
face
Glue the
googly eyes right above the nose
Glue the
head to the puppet base
Slide the
cats arms in between the coils of the puppet base
body
Tie a bow with a red pipe cleaner
around the neck, and use your wire cutters to trim
the extra length of the ends
off